Fix a leaking tap in Singapore with the help of this simple guide. A leaking tap issue, although very common, can be quite frustrating. Leaks can occur in the form of simple drips or steady streams. Whatever the issue, leaking taps can waste a lot of water and can even put a toll on the water bill.Â
Many users need to call professional plumbers to fix the tap, but a leaking tap can be fixed without the need for a professional. All you need is the right set of tools and a guide to help you through the process. With a little bit of skill and patience, you can have a working tap in no time. We are here to provide you with the ultimate guide to fix a dripping tap. Follow along to get your tap fixed in no time.
LS Plumber Singapore provides a step-by-step guide to fixing a leaking tap in Singapore. They have decades of experience in services like sink pipe repair, toilet bowl leaks, and toilet flush installation.Â
How to Fix a Leaking Tap: Step-By-Step GuideÂ
Here is the step-by-step guide to fix a leaking tap in Singapore:
Gather The ToolsÂ
To fix a leaking water tap, you will need a few tools. Most of these tools are quite easy to find and can be found in every toolbox. However, if you don’t have any of these in your house, you will have to buy a new one before proceeding with the tap repair.Â
Here are the tools you are going to need:Â
- Replacement washers or O ringsÂ
- Plumbing tapeÂ
- Adjustable wrenchÂ
- Basin wrenchÂ
- Silicone sealantÂ
- Bucket to catch waterÂ
- Clean clothÂ
2. Turn Off The Main Water Supply
The next step in the leaking tap repair is to turn off the water supply to the basin. For this purpose, you will have to tighten the shut-off valves located under the sink. Each basin usually has its supply valves connected to the main water supply. You can also turn off the water by disconnecting the main water supply pipe feeding the basin.Â
3. Identify The Type Of Tap
The next step is to identify the type of tap you have in your basin. Four common types of taps are usually found in Singapore:
- Compression Tap: A compression tap has separate handles for hot and cold waters.
- Mixer Tap: A mixer taps mixes hot and cold waters and sends out a single stream
- Ball Tap: This type of tap uses a ball mechanism to control the water flow
- Ceramic Disc Tap: This tap has a cartridge filled with ceramic discs for controlling water flow
Identifying the exact type of tap in your house is essential because each type has its own repair measures. To get accurate information, contact your house’s construction company.
4. Disassemble The Tap
The next step is to disassemble the tap to find out the exact source of the leak. Remove the decorative cap to expose the assembly screw. Remove this screw to open the tap handle. Then, an adjustable wrench is used to remove the bonnet or cover plate covering the internal parts of the tap. Be careful during this process to avoid damaging the internal parts of the tap.
Inspect The Internal Parts And Replace Old Ones
Inspect the internal parts of the tap and replace the old ones. Each type of tap is going to have different parts, such as:
- Compression Tap: Check the rubber washer at the bottom of the valve. If it is damaged or worn out, replace it with a new one
- Mixer Tap: Inspect the O rings and replace them if worn out.
- Ball Tap: Inspect the ball mechanism and the inlet seals. Replace them if they are worn out.Â
- Ceramic Disc Tap: If the ceramic discs or the cartridge is damaged, the whole unit needs to be replaced.
6. Reassemble The Tap And Turn On The Water Supply
The last step in leaking tap repair is reassembly. Once you have replaced the worn-out parts, assemble the tap again by going in reverse order of the disassembly. Apply the plumber’s tape to the threads of the tap parts to create a tight and leak-proof seal. Turn the water supply back on and observe for leaks. If the replacement has been done correctly, no water should leak from the tap now.Â
Conclusion
We have discussed in detail the complete process to fix a leaking tap. Using this guide, you can easily fix any issues with your tap and can prevent water loss and excessive bills. With a little skill, you can fix a water-leaking tap yourself and don’t need any professional help.
However, for large leaks of water from the tap or any other area of plumbing, we recommend taking the help of professional plumbers. They can identify the source of the leak and can professionally solve it with their high-end tools. They can also inspect your entire plumbing system to see if any other areas need repair.